ARRI ARRI RCU-4 Manual de Instruções descarregar pdf (Página 11)

Remote Control Unit – 1

2. 2 Switching on

The RCU-1 does not have its own on/off switch. It

is supplied directly through the camera via the con-

nection cable, as soon as the camera is switched on.

The display of the RCU-1 illuminates red as long,

as the camera is on.

The READY-LED changes from blinking red to per-

manent green, once the communication has been

successfully established. The RCU-1 is now ready

for use.

2. 3 Important Notes

• Do not edit speed values on the camera, when

operating in the RCU mode, as these values are

going to be constantly overridden by the RCU-1.

The RCU-1 is an active unit, and its settings are

predominant to the settings of the camera. The

camera retains the values which had been set

with the RCU-1. This applies for switching back

from RCU to CAM mode, as well as if the RCU-1

is disconnected from the camera.

• All selected parameters, programs and user de-

fined end-stops are stored in the RCU-1 even if it

is disconnected. Therefore it is possible that user

defined end-stops programmed into the RCU-1

are not available with a currently connected

camera – i. e. end-stops have been programmed

for a highspeed camera and the RCU-1 is later

used on a regular production camera. The RCU-1

automatically recognises the connected type of

camera, but does not automatically change pro-

grammed values.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

Sem comentários

ARRI ARRI RCU-4 Manual de Instruções Página 11